AMCC 3WARE 9500S Guia do Utilizador descarregar pdf (Página 138)

Chapter 8. Configuring Units

128 3ware Serial ATA RAID Controller User Guide

3 Power down the system, disconnect the drives from the 8000 controller

and remove that controller from the system.

4 Attach the drives to the 9000 board.

5 Reboot the system and enter the 3ware 9000 series BIOS (3BM) by

pressing Alt-3. Enable the Export JBOD policy on the Policy screen.

6 Press the

F8 or Esc key to save and exit.

To move legacy JBOD units under Linux or FreeBSD

1 Upgrade your driver to the 9000 series driver.

2 Power down the system, disconnect the drives from the 8000 controller

and remove the controller from the system.

3 Install the 9000 controller and attach the drives to the 9000 board, as

described earlier in this section.

4 Reboot the system and enter the 3ware 9000 series BIOS (3BM) by

pressing Alt-3. Enable the Export JBOD policy on the Policy screen.

5 Press the

F8 or Esc key to save and exit.

Moving Units from a 9500S to a 9550SX, 9590SE, or

9650SE Controller

It is fairly straightforward to move units from a 9500S controller to a 9550SX,

9590SE, or 9650SE controller. The steps you follow depend on whether you

are booting from the drives attached to the 9500S, or whether they are being

used for secondary storage.

To move a bootable unit from a 9500S to a 9550SX, 9590SE, or

9650SE controller

1 If you are working with a Linux system, skip to step 2.

If you are working with a Windows system:

a Power down the computer.

b Install the 9550SX, 9590SE, or 9650SE controller in the computer,

leaving the 9500S installed and its drives attached.

c Boot to the operating system.

2 Update the driver for the 9550SX, 9590SE, or 9650SE.

If you are using Linux, you will also need to update the initial RAM disk

with the

mkinitrd command.

3 Power down the computer.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 301 302

Sem comentários

AMCC 3WARE 9500S Guia do Utilizador Página 138